Nozzle must have the ohmic resistance in the range of 2 to 3 ohms, although measures the column indicates that the electrical resistance of the injector, as per the expectations.

If you try the injector and shows the value of 1, then this means that the injector electrical system is broken because the value of 1 means infinite resistance, in other words, there is no continuity due to a short coil injectors.

Before a failure in the end will have to replace the injector, so that the lid is removed from the base of the body of the injector, and then get the screw area.

Finally, put on the injector to force something down while you, to achieve the disassembly of the injector.

Now, to put the new injectors can reverse and repair it completely.

Cleaning nozzles.

Can show some weaknesses in the nozzles because coal nozzle deposits, and this is the point at which you will exit from the fuel injection.

These deposits can block the hole by changing the flow of the jet and could crash the system.

To make the cleaning of the injector on the market quickly find the cleaning of equipment, which is based on ultrasound and achieves a very effective cleaning thanks bubbles produced by ultrasound in the used cleaning liquid.

The method of using the device is pretty simple, just put the cleaning fluid recommended by the manufacturer of the device in the container, making sure that this level corresponds to stamp marked on the container.

Then the fuel injection nozzle placed in the removable tray for cleaning dirt with a hole that fits over the width of the nozzle and the nozzle tip to the bottom, which is done by placing the disc is immersed in the cleaning liquid.

Then placed on the disc and cleaning the device timer is set to 10 or 20 minutes, we can increase the cleaning time up to 1 hour, if we are dealing with very dirty injectors and use, the device heater to increase the effectiveness of cleaning.

If you are not yet a machine ultrasonic cleaning and decide to buy one, you should buy the models are some of the features mentioned and should signal switches to connect the nozzle during cleaning.