Detailed Product Description

SP-11 is a new one-pack Vinyl resin wall coating system with the follow properties:

Innocuous, harmless for surroundings.

Very high chemical resistance.

Anti-mildew, anti-alga under the high temperature, high humidity and more glucide surroundings.

Excellent abrasion resistance.

Application areas

Conditions requiring the maximum of chemical resistance, health and safety and protection of surfaces subject to impact. It is ideal for:

Chemical industries.

Food and drink plants.

Pharmaceutical and cosmetic plants.

Packing and colours

SP-11 Part A: 15kg containers.

SP-11 Part B: 15kg containers.

SP-11 is available in large range of colors. For available colors, please refer tocolor chart.

Product description
SP-11 is a new one-pack Vinyl resin wall coating system with the following properties:
l Innocuous, harmless for surroundings;
l Very high chemical resistance;
l Anti-mildew, anti-algae under the high temperatures, high humidity and more glucide
surroundings.
l Excellent abrasion resistance.
Application areas
For conditions requiring the maximum of chemical resistance, health and safety and
protection of surfaces subject to impact. It is ideal for:
l Chemical industries.
l Food and drink plants
l Pharmaceutical and cosmetic plants.
Resistance to chemicals etc
Anti-10% sulfuric acid No change in 55 days
Anti-10% sodium hydroxide No change in 55 days
Anti-3% salt water No change in 55 days
Water resistance No change in 48 hours
Application instructions
Surface preparation
l The compressive strength of the concrete substrate should not be less than 25N/mm2,
the best application temperature is between 10--25.The air humidity must not be
higher than 80%, the moisture content of the substrate shall not be higher than 8.
l Correct substrate preparation is critical for optimum performance. Surfaces should be
sound, clean, dry and free from loose particles, oil, grease, and all other
contaminants
l Remove oil, grease by scrubbing. Cement laitance, loose particles, pitch and other
contaminant must be removed from the surface by sand-blasting. The alkalinity and
porosity of the surface must also be considered when painting.
l Fill surface cracks with Epoxy-Reinforced Solvent-Free repair mortar to achieve a
level surface.