Advantages:
(1).Electrical control, operation easy
(2). Workbench multi-faceted trim
(3). Pressure, temperature, speed adjustable
(4).Automatic document feeder, the collection of paper, and adjustable
(5). Workpiece mold with built-preheating device.
Operation
1.The table tiling cardboard or plastic sheet, and use the board rubber stamping mold fixed to find good rules.
2. Anodized aluminum in order installed, note the folder anodized aluminum spring should not tai chi or too loose, not to hold against the anodized aluminum, adjust the length of the pull rod and pendulum with gold foil paper about distance module 100mm.
3. Close the power switch to start heating up the heating equipment in the case of its set parameters unchanged.
4.Stamping pieces flat on a workbench, hand press handle trial printing, stamping parameters not set reset
Hot stamping temperature reference
Paper:85-120 °C
PVC:65-80 °C
soft soft plastic:75-85 °C
Hard plastic artificial leather:120-150 °C
Synthetic leather leather:160-180 °C
The stamping process the matters needing attention:
(1). According to the different varieties of scalded object, select the appropriate hot stamping foil.Good sized
must master the temperature, pressure, stamping speed three party coordination, and according to the
short-run printing materials, area of difference.
(2).The cutting knife should grasp the direction and speed of car;
(3).The anodized hot stamping foil should choose attributes suitable paper, ink (especially black kerosene, composite glue, hot stamping parts must be kept dry, so as to avoid the bronzing layer oxidizing or injury;
(4). The general packaging: 0, 64 × 120m volumes, each volume 10: a box can be custom width of 0.64M, length of 240m or 360m rolls or other special specifications;
(5). When stored to prevent pressure, moisture, heat, sunscreen, placed in a cool ventilated place.
